All submissions of the EM system will be redirected toOnline Manuscript Submission System. Authors are requested to submit articles directly toOnline Manuscript Submission Systemof respective journal.

Microwave Promoted Metal Free Deuteration of Anilines by I/D Exchange with D2O as a Deuterium Source

Gao WQ1*, Qiao YB2and Qin YQ1

1Department of Chemistry and Chemical Engineering, Luliang University, Lvliang, PR China

2Graduate Institute of Pharmaceutical Chemistry, Luliang University, Lvliang, PR China

*Corresponding Author:
Gao WQ
Department of Chemistry and Chemical Engineering
Luliang University
Lvliang, PR China
Tel:+8603582274242
Fax:+8603582274242
E-mail: [email protected]

Received date:24/06/2016;Accepted date:01/07/2016;Published date:06/07/2016

Visit for more related articles atdota2雷竞技

Abstract

A microwave promoted I/D exchange deuteration of anilines method was developed. Under microwave condition, this exchange could be completed in a short time with D2O as a deuterium source. Furthermore, only thionyl chloride was used as additive.

Keywords

Deuteration of anilines, I/D exchange, D2O.

Introduction

Isotopic labelling is a technique, which has been widely used in chemistry and biochemistry to help understand chemical reactions and interactions, as well as stable isotopes in pharmacokinetic studies as biological internal standards. Usually, D2O is the cheapest deuterium source, so far [1] several methods have been developed for the synthesis deuterium-labelling compounds through H/D exchange with D2O, deuterium gas and deuterium solvents. The common pathways are pH-dependent H/D exchange [2-6] and metal catalyzed H/D exchange [7-13]. Most of these methods have some disadvantages, such as time consuming, lower efficacy, very high reaction temperature, and expensive deuterium source, as well as precious metal was used as catalyst in most of these cases. Other methods for achieving deuterium-labelling compound through including decarboxylative deuteration, I/D exchange. It is well-known that deuterium-labelling anilines are a type of important intermediate due to its good reactivity, and a few of methods for synthesizing deuterium-labelling anilines have been reported. In 2008, Mutsumi et al. [14] reported a tributyltin hydride promoted I/D exchange reaction for deuteration on pyrimidine and purine nuclei with THF-d8as deuterium source. After that, Lautens et al. [15] developed a palladium mediated coupling-reductive method for obtaining meta-substituted biaryls. In both above mentioned method for deuterating aromatic compounds are highly expected. On the other hand, high-speed microwave synthesis has attracted a considerable amount of attention in the last two decades. Compared with conventional heating, microwave irradiation displayed a number of advantages, not only in heating effect, but also good selectivity and higher yield in many microwave promoted reactions [16,17]. Herein, we would report a microwave promoted I/D exchange method for getting deuterated aniline with D2O as an inexpensive deuterium source.

Experimental

General information

Unless otherwise noted, commercial reagents were used as received.1H (400 MHz) and13C (100 MHz) NMR chemical shifts were reported in CDCl37.27 ppm for1H, 77 ppm for13C作为标准和耦合常数repor (J)ted in hertz (Hz). The following abbreviations are used to designate signal multiplicity: s=singlet, d=doublet, t=triplet, q=quartet, m=multiplet, br=broad.

一般程序

In a 25 ml of seal tube, aniline (2 mmol), D2O (3 ml) and SOCl2(0.2 ml) was added successively. Then this tube was irradiated under microwave at 130°C for 30 min. After cooled to room temp., the reaction was diluted with water, and neutralized with NaHCO3, extracted with diethyl ether (50 mL × 3), the combined organic layer was washed with brine, and dried with anhydrous Na2SO4. Removal of all volatiles by vacuum evaporation left a residue, which was purified by flash chromatography to afford product.

2-deuterium-4,6-dimethylaniline (2a).Colorless oil;1H NMR (400 MHz, CDCl3): δ 6.86 (s, 1H), 6.83 (s, 1H), 3.44 (br s, 2H), 2.22 (s, 3H) and 2.13 (s, 3H);13C NMR (100 MHz, CDCl3): δ 141.98, 131.15, 127.87, 127.27, 122.50, 114.93 (1:1:1 t, J=23.5 Hz), 20.45, 17.33; HRMS (EI) calcd. for C8H10DN [M+] 122.0954, found 122.0955; IR (KBr): cm-1: 3266, 2920, 2866, 1687, 1635, 1510, 1482, 1300, 880.

4-deuterium-2,6-dimethylaniline (2b).Colorless oil;1H NMR (400 MHz, CDCl3): δ 6.94 (s, 2H), 3.57 (br s, 2H) and 2.81 (s, 6H);13C NMR (100 MHz, CDCl3): δ 142.66, 128.23, 121,86, 117.92 (1:1:1 t, J=24.5 Hz), 17.69; HRMS (EI) calcd. for C8H10DN [M+] 122.0954, found 122.0956; IR (KBr): cm-1: 3260, 2960, 2850, 1730, 1620, 1545, 1260, 1080, 1025, 970, 803, 662.

2-deuterium-4-phenyl-6-methylaniline (2c).Colorless oil;1H NMR (400 MHz, CDCl3): δ 7.54-7.52 (m, 2H), 7.40-7.36 (m, 2H), 7.31-7.22 (m, 3H), 3.63 (br s, 2H) and 2.22 (s, 3H);13C NMR (100 MHz, CDCl3): δ 144.07, 141.39, 131.70, 129.26, 128.66, 126.50, 126.20, 125.59, 122.59, 115.00 (1:1:1 t, J=23.5 Hz), 17.55; HRMS (EI) calcd. for C13H12DN [M+] 184.1111, found 184.1115; IR (KBr): cm-1: 3330, 3322, 3000, 2941, 2920, 2830, 1620, 1480, 1300, 1267, 1081, 1030, 897, 770, 699.

2-deuterium-4-methyl-6-phenylaniline (2d).Yellow oil;1H NMR (400 MHz, CDCl3): δ 7.45-7.40 (m, 4H), 7.34-7.30 (m, 1H), 6.96-6.95 (m, 2H), 3.55 (br s, 2H) and 2.27 (s, 3H);13C NMR (100 MHz, CDCl3): δ 140.94, 139.73, 131.00, 129.12, 128.95, 128.78, 127.88, 127.78, 127.11, 115.56 (1:1:1 t, J=24 Hz), 20.45; HRMS (EI) calcd. for C13H12DN [M+] 184.1111, found 184.1117; IR (KBr): cm-1: 3452, 3350, 2922, 1623, 14389, 1265, 872, 779, 742, 698, 587.

2-deuterium-6-bromo-4-methylaniline (2e)Yellow oil;1H NMR (400 MHz, CDCl3): δ 7.23 (s, 1H), 6.90 (s, 1H), 3.92 (br s, 2H) and 2.22 (s, 3H);13C NMR (100 MHz, CDCl3): δ 141.52, 132.74, 129.09, 128.92, 115.54 (1:1:1 t, J=24.5Hz), 109.34, 20.09; HRMS (EI) calcd. for C7H7BrDN [M+] 185.9903, found 185.9904; IR (KBr): cm-1: 2926, 2848, 1730, 1507, 1465, 1269, 1080.

2,6-dideuterium-4-methylaniline (2f)Yellow oil;1H NMR (400 MHz, CDCl3): δ 6.96 (s, 2H), 3.51 (br s, 2H) and 2.24 (s, 6H);13C NMR (100 MHz, CDCl3): δ 143.72, 129.66, 127.79, 115.01 (1:1:1 t, J=23.5 Hz), 20.47; HRMS (EI) calcd. for C7H7D2N [M+] 109.0861, found 109.0866; IR (KBr): cm-1: 3290, 2970, 2930, 2870, 1734, 1678, 1600, 1477, 1274, 1203, 1090, 985, 905, 775, 502.

2,4,6-trideuteriumaniline (2g)[6] Yellow oil;1H NMR (400 MHz, CDCl3): δ 7.15 (s, 2H) and 3.62 (brs, 2H).

1-(4-amino-3,5-dideuterophenyl)-2,2,2-trideuteroethanone (2h)[17] Yellow oil;1H NMR (400 MHz, CDCl3): δ 7.79 (s, 2H) and 4.33 (br s, 2H).

Results and Discussion

Our work was initialed by using 2-iodo-4, 6-dimethylaniline 1a as substrate, which was refluxed in CD3OD in the presence of thionyl chloride for 12 h, 2-deuterium-4,6-dimethyl -aniline was obtained at 20% yield (Table 1). When CD3OD was replaced with cheaper D2O, and the reaction was refluxed for 12 h, I/D exchanged product was obtained in 24% yield (Table 1). Further prolonging the reaction time could not increase the yield (Table 1). Next, the microwave irradiation was applied to promote this reaction, to our great delight, when 4-iodo-2,6-dimethylaniline was heated in a sealed tube by microwave irradiation with D2O in combination with SOCl2at 100°C for 15 min., I/D exchanged product was obtained in 56% yield (Table 1). When the reaction time was prolonged to 30 min., 84% yield was obtained (Table 1).

table
Entry Solvent Reaction condition Yield(%)b
1 CD3OD/SOCl2 reflux, 12 h 20
2 D2O/SOCl2 reflux, 12 h 25
3 D2O/SOCl2 reflux, 24 h 26
4 D2O/SOCl2 MW(100°C, 15 min) 56
5 D2O/SOCl2 MW(100°C, 30 min) 84

Table 1:Optimization of the reaction conditionsa

With this optimized reaction condition, other iodine substituted anilines were also extended. Most of these iodine substituted anilines could be transferred to corresponding I/D exchanged products with moderate to good yield (Table 2). The Br/D exchange be observed, singe I/D exchanged product and double deuterium product were obtained (Table 2) led to lower yield of 2e. As shown inTable 2, I–D exchange reaction of all reactants to achieve a high D content.

table
Entry Substrate R1 R2 R3 Product D contenta(%) Yield (%)b
1 1a Me Me I 2a 99 84
2 1b Me I Me 2b 98 80
3 1c Me Ph I 2c 98 85
4 1d Ph Me I 2d 98 85
5 1e Br Me I 2e 97 26
6 1f I Me I 2f 99 73
9 1g H H I 2g 98 67
10 1H H Ac I 2h 98 80

Table 2:I/D exchange on aniline using D2O as a deuterium source.

The possible mechanism can be proposed asScheme 1. First, thionyl chloride reacted with D2O to produce DCl in situ, which act as an electrophile. The amino group in aniline is strongly activating and ortho/para-directing group, when the electrophile DCl attacks the ortho positions of aniline, the nitrogen atom can donate electron density to the π system to form an iminium ion, then chloro ion attacksiodine to form ICl.

chemistry-possible-mechanism-exchange

Scheme 1:The possible mechanism of I/D exchange.

Conclusion

In conclusion, a microwave promoted I/D exchange deuteration of anilines method was developed. Under microwave condition, several iodo anilines could be rapidly and efficiently deuterated in a short time with D2O as a deuterium source.

Acknowledgements

We are grateful to Shanxi Natural Science Foundation Committee (Project No.: 2012011002-3), Shanxi High School Development Project of Science and Technology Research (Project No.: 20101154; 2013168), Luliang University Science and Research Foundation (Project No.: ZRXN201211). The authors are also very grateful for the English and manuscript suggestions by Prof. Bai, J.M. and Bogan, A. from department of foreign language, Luliang University.

References

Global Tech Summit